Categories
Cart 0 items
Your cart is empty
1/4 Scale Fouga Magister CM 170 Aviation design

The Fouga Magister was the follow up trainer for KLU where the jet pilots were trained by the Belgian Air Force earlier.

Also this jet flown by the French aerobatic team Patrouille De France.

Because of its long narrow wing it easy to fly and also has good glide performance and is suitable to take. Use after basic jet trainer as a follow up

CHARACTERISTICS:
SCALE: 1/4
WING SPAN: 3.04 m (120 ")
LENGTH: 2.52 m (99 ")
TURBINE WITH WEIGHT: 17-18 kg (37-40 lbs)
 
MODEL DESCRIPTION
THE Fouga Magister 1/4 SCALE, QUALITY AND PERFORMANCE ...
 
AVIATION DESIGN KIT DESIGNED BY ERIC RANTET
 
Fouga Magister kit - RC Jets models - Aviation Design
Fouga Magister turbine installation - RC Jets models - Aviation Design

Image Next Image
The Fouga Magister has leg the French jet trainer for the Air Force and the Navy since 1957. It was built by a small french company Castel Mauboussin.
More than 900 Fouga have been built and a lot of them are sold worldwide. (Germany, Austria, Brasil, Finland, Ireland, Israel ...).
Until 1981, the Fouga was used by the "Patrouille de France", the french aerobatic display team. All the french Fouga are now retired and a lot of them are now flying by private pilot all over the world.
The Fouga Magister from AVIATION DESIGN is designed for a single turbine.
It is a scale kit, built from the original "Castel Mauboussin factory" plans from 1955. All the panel lines and rivets (about 15 000) are engraved in the fuselage and wings.
It is fully molded in composite carbon fiber / epoxy and pre-assembled: model is painted in mold, all bulkeads are glued.
The wings are molded with carbon fiber reinforcement. The aluminum wing spar, the alignment pins are factory installed.
The two stabs (called butterfly stabs) are usefull molded with carbon fiber reinforcement.
The second canopy hatches are molded in epoxy and the canopy fitting is easy. No important gluing is required.
Up to 80% of the work is done in our factory.
 
THE FLIGHT CHARACTERISTICS ARE EXCELLENT:
It is a very easy to fly model, with an excellent stability.
Take off is very simple: just throttle up and the Fouga will take off automatically.
All aerobatics maneuvers can be done, the loops are enormous, roll can be done fast or slow. Inverted flight is possible.
For landing, the air brakes are powerfull and they have no pitch effect, so landing precision is excellent. The Fouga has alsovery good low speed capability.
If the turbine stops, no problem: the original Fouga was a glider designed by engineer team. So with enough speed or altitude, you can do a complete circuit and a perfect landing without Difficulties.
Fuel tanks are designed large enough (4 liters) to have a minimum of 10 minutes of flight.
 
The Fouga Magister will operate from prepared grass fields or tarmac surfaces.
Minimum size engine is a single 10 kg (22 lbs) thrust turbine. It will take off from grass in about 200 meters (650 ft) and 150 meters (490 ft) from tarmac.
Maximum size engine is a single 16 kg (40 lbs) thurst turbine. It will take off in about 50 meters (160 ft) from tarmac and 70 meters (230 ft) from grass.
 
The model has plug in wings and stabs. The fuselage can be disassembled into two parts for transportation and access to bifurcated pipe.
The Fouga Magister is designed for an easy assembly and an easy utilization and maintenance.
The big hatches give a good access to the radio, batteries, engine, equipment, fuel tank, pump and to the bifurcated tailpipe.
 
Our landing gear have been designed for stronger field operation.
 
KIT FEATURES:
• High quality, gray gel-coated epoxy glass fuselage. The fuselage is in two parts for shipping;
• Front hatch for radio and engine hatch that demand no framework molded in epoxy glass;
• 2 canopy frames molded in epoxy-glass;
• 2 epoxy-glass inlet ducted;
• Fully molded epoxy carbon wings with aluminum spar already glued;
• Fully molded epoxy carbon stabs;
• Wing tip tanks;
• 2 clear canopy formed;
• Full size CAD plans and instructions in English.
Product 2/474
 Previous   Return to the Product List   Next 

1/4 Scale Mouga Magister CM 170 Aviation Design

1/4 Scale Fouga Magister CM 170 Aviation design The Fouga Magister was the follow up trainer for KLU where the jet pilots were trained by the Belgian Air Force earlier. Also this jet flown by the French aerobatic team Patrouille De France. Because of its long narrow wing it easy to fly a...
in Stock

Shipping Option

Starting at: $1,345.00